Smart Machine Instructions

SET UP:

The Smarts Fairy floss machine needs it own power point.  The head has a heating element inside which draws a lot of power.  It is important not to run any other machines on the same power point! Also important to place the machine out of the wind and under cover.

Place the machine on a sturdy table or fit legs provided.  Fit bowl around collar and place bubble inside lip of the bowl (secure the bubble with the bolt). Then sure there is sugar in the head of the unit. Then wipe the outside of the bowl with a damp cloth (to give the floss something to stick to). 

Turn on both switches on and turn the heat to 8 or 9. It will only take a couple of minutes to heat up. Once it starts making floss; turn the machine down to around number 5. The higher you have the machine. the faster the floss comes out.

MAKING A STICK OF FLOSS:

Once a little bit of floss has built up on the outside. Place your stick inside the bowl and twirl the stick in your fingers and also move in an clockwise direction.  Avoid rolling the stick of floss along the side of the bowl. Until you make it to the size you want. Refill the sugar in the head every 5-6 sticks (while the machine is running). Please Note: if you don't refill the head often then the machine will get too hot and floss will go thick like rope and burn and if you over fill the machine; it will come off balanced.

CLEANING THE MACHINE:

When finished for the day, turn the floss control to 1. Then turn off the heat switch and let the motor run for about 2 minutes to cool the head down before turning off the machine.

Lift off the bowl and bubble from the machine and then wash the bowl and bubble with warm water and a mild detergent. No harsh rubbing or chemicals! Warm water and a soft sponge will dissolve the sugar.

Wipe over cabinet and neck with a damp cloth. BUT do not wipe or wash the head of the machine. 

Important Notice:

Do not attempt to operate the machine from portable generators.